Drive your car up to the gooseneck and tie the lazy end of traveler up with wire and linemen
Take the working end of the traveler and tie that up with a rope, with the other end of the rope tied to the car
Clip the well wheel to the jib or tie arm and raise the car to pick up the traveler
Once the traveler is loose from the gooseneck, remove it and put it in the car
Loop the cable around the well wheel
loosen the rope until the traveler hangs from the well wheel
drive the car up until you have reached the next position drive and be careful about the wire tied to the lazy end
once you have reached the next position put the gooseneck back on the tower
drive past the gooseneck
tie a rope back around the working end and another around the lazy end of the traveler and wrap the other end of each rope around the tower
The ropes control the slack of the traveler
Lower the traveler onto the gooseneck
lower the car until the traveler hangs from the tower, keep tension on the ropes
remove the traveler from the well wheel, transfer it back to the gooseneck
now slowly loosen the ropes until the cable is hanging from the gooseneck again
now tie off the cable to the tower with wire using linemen
as you drive the car down continue to tie off the lazy end with wire
when you get to the donkey **** tie a rope around the cable below it and loop the other end around the car
slightly pick the cable
tie of wire below and above the donkey **** using the linemen
secure the cable to the tower with wire so that there is not too much strain on the donkey ****
make sure the donkey **** will not hit the car or trolley as they drive past it
loosen the rope from the cable and continue to drive the car down
drive the car down
go home